Sep 18, 2009
We recently designed and shipped a very large conveyor setup for a customer who was moving large stamped parts out of a press. Due to the width of the parts, a very wide conveyor was needed. Our solution was to mate two AS40 Automation Series Conveyors together in a gang driven configuration. Read More →
Sep 15, 2009
One of our distributors, TCR Integrated Stamping Systems, recently designed and installed a system for Polaris Industries in Osceola, WI. Their writeup of the solution was featured in the July/August '09 Metalforming Magazine. Read More →
Aug 31, 2009
In this case, we were asked by a pharmaceutical customer to design a Lexan cover that fits over the top of the conveyor to keep dust out. This cover is hinged to allow it to flip open for cleaning. Read More →
Jul 21, 2009
We often are asked to develop unique conveyor systems for customers. This particular system is unique in that the project consisted of three tiers. Parts would move in a loop on the lower two tiers and a takeaway conveyor would make up the top tier. Read More →
Jun 10, 2009
Today we shipped a set of AS40-CD conveyors that contained two unique modifications from our specials engineering department: a cutout in the frame and a gang drive system. Our customer requested the cutout to allow a robot arm to pass under the conveyor; even our normal low profile wasn't enough in this case. Read More →
Jun 05, 2009
I'm excited to announce that QC Conveyors' new Automation Series low profile belt conveyor has received one of New Equipment Digest's Best of 2009 Awards. Read More →
May 29, 2009
Our Automation Series Conveyors now have a new option available: a nosebar tail. This will allow for even better transfer of small parts between conveyors or other integrated machines. Read More →
May 18, 2009
Our longest Automation Series conveyors feature under-frame idlers to prevent belt slack from hanging below the frame. Conveyors 6" wide or less receive partial-width idlers, while wider conveyors get a full-width idler that runs the entire width of the frame. Read More →
May 08, 2009
The frames for our 2”–12” wide Automation Series conveyors are extruded from a single piece of aluminum, but for wider widths (18”, 21”, 24”) this wasn’t possible, so we designed a three-piece frame construction. Read More →
Mar 04, 2009
At QC Conveyors, we can proudly say that all our conveyors are "American Made." More than 85% of the parts across all our conveyor lines are sourced domestically. In fact — as part of our efforts to keep our carbon footprint as small as possible — more than 60% of the parts are sourced within 100 miles of our headquarters. Read More →
By submitting this information, you are agreeing to our Privacy Policy.